Ash content tester

I. equipment introduction

 

This equipment is heated by resistance wire, temperature range is room temperature - 900 ℃, it is specially used for ash content test of plastic particles and plastic products.

 

This equipment has two models of tc-2600 and tc-3600, of which tc-2600 is intelligent digital display and tc-3600 is touch screen control, which can be calculated and printed.

 

II. Main technical parameters

 

Model tc-3600

 

Rated power (kw): 3.0kw

 

Rated voltage (V) 220

 

Rated temperature (℃) 900 ℃

 

Phase number 1

 

Temperature rise time of empty furnace (min) ≤ 60

 

Empty furnace power (kw) ≤ 2.5kW

 

Furnace size round

 

（l×b）(mm) 200*160

 

Outline size

 

（l×b×h）(mm) 500*420*420

 

Weight (kg) 30

 

III. structure introduction

 

This machine is a fully sealed cabin structure, and the exhaust gas can be discharged uniformly (the exhaust device shall be provided by the customer). The bottom of the equipment is thermocouple, and the upper part of the thermocouple is experimental chamber. The experimental cabin is surrounded by a thermal insulation layer. The upper part of the experimental cabin is the hatch cover.

 

 

 

IV. installation and use

 

1. The electric furnace does not need special installation. It only needs to be placed on a flat ground or on a shelf. The controller shall avoid vibration, and shall not be placed too close to the electric furnace to prevent the electronic components from working normally due to overheating.

 

2. Observe whether the temperature display is normal after start-up, and whether the cold engine starts to display room temperature.

 

3. The power of this machine is large, so it must be grounded during use.

 

4. For specific operation, please refer to the operation instruction of the instrument.